Delphi TC8023 rear trailing arm for the 2010-2015 Chevrolet Camaro locates the rear wheel and holds it in line as the suspension moves. This suspension trailing arm is a standard replacement, one of the trailing arms Delphi makes for the 2010-2015 Chevrolet Camaro.
- 100% crack detection and ultrasonic flaw detection on the arm's materials
- Robot welding for consistent quality
- Anti-corrosion protection applied to each arm
- Withstands temperatures below -40 °C and above 120 °C and 720 hours of salt spray exposure
Quick facts
- Part: Delphi TC8023 trailing arm
- Also called: suspension trailing arm
- Fits: 2010-2015 Chevrolet Camaro
- Position: Rear
- Material: Steel
- Condition: New
A worn trailing arm can show up as a clunk from the rear over bumps, a loose or wandering rear end, or uneven rear tire wear. Shocks, other bushings and alignment can produce those signs too, so with the engine off, look over the rear tires for uneven wear and have a shop inspect the rear suspension before you replace anything.
Fits
This is a direct-fit replacement for the 2010-2015 Chevrolet Camaro, which takes two, one on each side of the rear axle. This listing is one arm; the other side of that axle is normally done at the same time.
Specifications
Fit and size
- Position: Rear
- Quantity per vehicle: 2
Build and materials
- Material: Steel
- Type: Standard replacement
- Condition: New
Interchange: 520-759
LL90975 · 92246140 · CA91535 · CA91535PR · RK643542 · CMS501106 · GS501106
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
520-759, LL90975, 92246140, CA91535, CA91535PR, RK643542, CMS501106, GS501106
Frequently Asked Questions
Is the Delphi TC8023 rear trailing arm right for the 2010-2015 Chevrolet Camaro?
Yes, Delphi TC8023 is a direct-fit rear trailing arm for the 2010-2015 Chevrolet Camaro. The car takes two, one on each side of the rear axle.
What is the Delphi TC8023 trailing arm made of?
The Delphi TC8023 is a steel arm with anti-corrosion protection applied to each part.
How is this rear trailing arm tested for rust and extreme temperatures?
This arm withstands temperatures below -40 °C and above 120 °C and 720 hours of salt spray exposure. Its welds are made by robot.
Can a worn rear trailing arm cause a clunk over bumps?
Yes, a worn arm or its bushing can. Shocks and other suspension parts can also clunk, and uneven rear tire wear is another sign a shop can look into.
Does the Delphi TC8023 cross-reference to number 520-759?
Yes, 520-759 is one of the interchange numbers for the Delphi TC8023 trailing arm. The others are printed on the Interchange line at the bottom of the page.
