Keep your front disc brakes quiet and properly aligned with the Beck/Arnley brake hardware kit (P/N 084-1952), a front-position disc brake hardware kit designed as a direct replacement for the original equipment on foreign-nameplate applications. It drops in for the 2013 INFINITI JX35, 2014-2020 INFINITI QX60, 2015-2024 NISSAN MURANO, and 2013-2020 NISSAN PATHFINDER — see the Buyer's Guide tab for engine-level details.
Fresh hardware helps the pads seat, slide, and retract correctly, which limits rattle, uneven pad wear, and squeal. If worn or corroded clips and springs are the cause of your brake noise, this kit replaces them. Best practice is to fit new hardware whenever you service the front pads or rotors.
Interchange: 13662 · 11742067
This part cross-references / interchanges with the following part numbers:
What vehicles does the Beck/Arnley brake hardware kit 084-1952 fit?
It fits the 2013 INFINITI JX35, 2014-2020 INFINITI QX60, 2015-2024 NISSAN MURANO, and 2013-2020 NISSAN PATHFINDER. Check the Buyer's Guide tab for engine-level details.
Is this a front or rear brake hardware kit?
This is a front disc brake hardware kit, per the catalog position for the listed applications.
What does a disc brake hardware kit do?
It supplies the clips, springs, and related pieces that let the pads seat, slide, and retract correctly, helping limit rattle, squeal, and uneven pad wear.
Should I replace the hardware when I do a brake job?
It is good practice to install new hardware whenever you service the front pads or rotors, since worn or corroded clips and springs can cause noise and uneven wear.
What numbers does this kit interchange with?
It cross-references interchange numbers 13662 and 11742067.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
