DISC BRAKE ROTOR

Bring the rear brakes back to a smooth, quiet friction surface with the Hella Brakes Disc Brake Rotor (MPN 355122622), a direct-fit rear rotor for the 2005-2010 Volkswagen Jetta [All], 2006-2009 Volkswagen Rabbit [All], and 2008 Audi A3 [All]. This is the machined rear surface the disc pads clamp against, converting wheel motion into heat under braking.

Cast as a solid (non-vented) full-cast rotor from high-grade gray cast iron, its high carbon content helps the disc shed heat, while the softer casting material and high carbon work to dampen brake noise and vibration. It is built to meet OEM standards and is ECE R90 ready.

• Full zinc coating: provides rust protection.
• Gray cast iron, high carbon content: supports heat dissipation and helps reduce noise and vibration.
• Solid, non-directional, smooth surface: ready to install on either side.
• Ready to fit: ships with one fixing screw and a non-oiled surface, so no degreasing is needed before installation.

Specs: 256 mm (10.08 in) outside diameter, 11.90 mm nominal thickness with a 10.00 mm discard/minimum thickness, and 10 bolt holes on a 112 mm bolt circle. Does not include a wheel hub, wheel studs, wheel bearings, or an ABS tone ring. Country of origin: China. Manufacturer part number 355122622.

Sold individually (package quantity 1). The listed applications use two rotors per axle, so replacing both sides together as a matched pair is recommended for balanced braking. If a worn, scored, or below-minimum-thickness rotor is the cause of your rear-brake issue, this replaces it.