Keep hydraulic pressure moving to the front right brake with the Dorman – First Stop Brake Hydraulic Hose H38200, a flexible EPDM rubber hose that carries pressurized brake fluid from the steel hard line to the wheel while flexing with suspension and steering travel. It installs in the front right position as a direct-fit replacement for the 1982-1994 Dodge B150, B250 and B350, the 1995-1997 Dodge B1500, B2500 and B3500, and the 1982-1983 Plymouth PB150, PB250 and PB350.
Durable design: built with EPDM rubber and specially coated, corrosion-resistant treated-steel fittings.
Fitting ends: a banjo fitting with a 10 mm thread at End 1 and a female fitting with a 3/8-24 inside diameter at End 2.
Position-specific: manufactured to precise measurements for an exact front right fit and easy installation, with an overall length of 21.63 in.
In the box: one black brake hose, gaskets and a stamped-steel bracket; mounting hardware is not included.
DOT approved and tested to government-regulated safety and durability standards. Signs this hose may need replacing include cracked or bulging outer rubber, fluid seepage at the fittings, or a soft, spongy pedal from a ballooning hose. Replace it as part of a complete brake repair.
Interchange: 18J2022 · 18J307 · 87-40022 · 8740022 · B917102 · 612200 · HB-87022 · HB87022 · 77317 · 150.67022 · 4210852 · 52008296 · BH177317 · 350-40129 · 35040129 · NF38200 · 4538200 · BH38200 · 2201100 · BH106329 · F106329
Manufacturer part number H38200
This part cross-references / interchanges with the following part numbers:
Which vehicles does the H38200 brake hose fit?
It's the front right brake hydraulic hose for the 1982-1994 Dodge B150/B250/B350, 1995-1997 Dodge B1500/B2500/B3500, and 1982-1983 Plymouth PB150/PB250/PB350. See the Buyer's Guide tab.
What comes in the box?
One black brake hose, gaskets and a stamped-steel bracket. Mounting hardware is not included; consult the vehicle service information for the correct fasteners and whether they may be reused.
What is this brake hose made of?
The hose is EPDM rubber with a banjo fitting at one end and a female fitting at the other, both treated steel with a specially coated, corrosion-resistant finish.
Is this hose DOT approved?
Yes. It's DOT approved and its materials are tested to government-regulated safety and durability standards.
What are the signs my brake hose needs replacing?
Cracked or bulging outer rubber, fluid seepage at the fittings, or a soft, spongy brake pedal can indicate a failing hose. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.