Keep pressurized brake fluid flowing to the rear brake with the Dorman - First Stop Brake Hydraulic Hose H38353. This flexible hose carries hydraulic pressure from the rigid brake line to the wheel while flexing with suspension and steering movement, and it fits the rear center position as a direct-fit replacement for the 1985-1986 Jeep Cherokee, 1986-1989 and 1992 Jeep Comanche, 1985-1986 Jeep Wagoneer, and 1987-1989 Jeep Wrangler (All engines).
- Durable design: built with EPDM rubber and specially coated, corrosion-resistant fittings.
- Treated-steel ends: End 1 is a junction fitting with a 3/8 thread; End 2 is a female fitting with a 3/8-24 inside diameter.
- DOT approved: materials tested to exacting government-regulated safety and durability standards.
- Ready to install: 15.63 in overall length, finished in black; mounting hardware, a bracket, and a gasket or seal are not included.
Engineered to the original brake hose's fit, function, and performance for the listed vehicles and the rear center position, it is manufactured to precise measurements for an exact fit. A cracked, bulging, or leaking flexible brake hose can cause a soft or spongy pedal; if a failed hose is the cause, this replaces it.
Interchange: 18J424 · 87-40313 · 8740313 · B917227 · 610536 · HB-87313 · HB87313 · 073-1513 · 0731513 · 77523 · 150.67313 · 52001917 · 52003607 · 8952001917 · BH251900 · BH254070 · 350-42100 · 35042100 · BH38353 · 2203076 · BH113144 · F113144
Manufacturer part number H38353
This part cross-references / interchanges with the following part numbers:
18J424, 87-40313, B917227, 610536, HB-87313, 073-1513, 77523, 150.67313, 52001917, 52003607, 8952001917, BH251900, BH254070, 350-42100, BH38353, 2203076, BH113144, F113144
Frequently Asked Questions
Will this brake hose fit my vehicle?
It's a direct-fit replacement for the 1985-1986 Jeep Cherokee, 1986-1989 and 1992 Jeep Comanche, 1985-1986 Jeep Wagoneer, and 1987-1989 Jeep Wrangler (All engines). See the "Vehicles it fits" section.
Where does this hose mount?
It is cataloged for the rear center position.
What is the hose made of?
The hose uses EPDM rubber with an outer rubber sleeve, and the End 1 and End 2 fittings are treated steel with a corrosion-resistant coating.
What are the fitting sizes?
End 1 is a junction fitting with a 3/8 thread and End 2 is a female fitting with a 3/8-24 inside diameter; overall length is 15.63 in.
Are mounting hardware or a bracket included?
No. Mounting hardware, a bracket, and a gasket or seal are not included; consult the vehicle service information for the correct fasteners.
