Keep brake fluid flowing to the rear brake with the Dorman First Stop Brake Hydraulic Hose H621027, a flexible line that carries pressurized brake fluid from the chassis hard line to the wheel while flexing with suspension movement. It installs at the rear position (left or right) as a direct-fit replacement for the 2007-2010 Ford Edge and 2007-2010 Lincoln MKX (All engines), engineered to match the original hose's fit, function and performance.
- EPDM rubber build: the hose is made with EPDM rubber and a rubber outer sleeve for flexible, durable service.
- Corrosion-resistant fittings: a banjo fitting on one end (10 mm thread) and a female fitting (M10 x 1.0) on the other, both treated steel and specially coated to resist corrosion.
- Quality assured: DOT approved, with materials tested to government-regulated safety and durability standards.
- Position-specific fit: manufactured to precise measurements (about 19.38 in overall) for an exact fit and easy installation.
This listing includes one brake hose with a mounting bracket and gaskets; mounting hardware is not included, so consult the vehicle service information for the correct fasteners and whether they may be reused. Cracking, bulging, fluid seepage, or a soft, spongy pedal can be signs a brake hose may need replacing — if a failed hose is the cause, this replaces it. Made in China.
Interchange: 612672 · 150.61427 · 15061427 · 350-54195 · 35054195 · 7T4Z2282A · 8T4Z2A442A · BH382844 · 2202629 · BH143805 · F143805
Manufacturer part number H621027
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this brake hydraulic hose do?
It's a flexible line that carries pressurized brake fluid from the chassis hard line to the rear brake, flexing with suspension movement so the fluid path stays sealed as the wheel moves.
Which vehicles does it fit?
It's a direct-fit replacement for the 2007-2010 Ford Edge and 2007-2010 Lincoln MKX (All engines). Check the Buyer's Guide tab to confirm your vehicle.
What position is this hose for?
It's a rear-position hose and can serve the rear left or rear right side on the listed applications.
What's included in the box?
One brake hose with a stamped-steel mounting bracket and gaskets. Mounting hardware is not included; consult the vehicle service information for the correct fasteners and whether they may be reused.
Is it DOT approved and what is it made of?
Yes, it's DOT approved. The hose is made with EPDM rubber and a rubber outer sleeve, with treated-steel banjo and female fittings that are specially coated to resist corrosion.
Write a Review