Feed pressurized brake fluid to the rear right wheel with the Dorman - First Stop Brake Hydraulic Hose H622072, a position-specific flexible hose engineered to drop in like the original on the 2007-2013 Jeep Wrangler [All]. It carries hydraulic pressure from the hard line to the caliper while flexing with suspension and steering travel.
Signs this hose may need replacing include cracking, bulging, or fluid seepage at the fittings, or a soft, spongy pedal if the hose balloons under pressure. If a failed rear right brake hose is the cause, this replaces it. Country of origin: China.
Interchange: 614333 · BH384277 · 2207051 · Manufacturer part number H622072
This part cross-references / interchanges with the following part numbers:
Which vehicles does the H622072 brake hose fit?
It's a direct-fit replacement for the 2007-2013 Jeep Wrangler (All). Check the Buyer's Guide tab to confirm it matches your vehicle.
What position is this hose for?
It's a position-specific rear right brake hydraulic hose, manufactured to precise measurements for an exact fit and easy installation.
What is the hose made of?
It's made with EPDM rubber and specially coated, corrosion-resistant treated-steel fittings. The outer sleeve is rubber and the bracket is stamped steel.
What's included with this hose?
One brake hose, gaskets, and a stamped-steel bracket. Mounting hardware is not included—consult the vehicle service information for the correct fasteners and whether they may be reused.
Is this hose DOT approved?
Yes, it's a DOT-approved flexible brake hose with materials tested to exacting government-regulated safety and durability standards.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.