Keep brake fluid flowing to the front right wheel with the Dorman First Stop brake hydraulic hose, part number H622074. Built for the front right position, it is a direct-fit replacement for the 2007-2010 Jeep Wrangler. See the "Vehicles it fits" section for engine details.
Dorman precision-engineered this hose to match the original brake hose's performance, fit and function on specific vehicles and positions, so it works as one part of a complete brake repair.
- Ideal replacement: precision-engineered to perform like the original brake hose on specific vehicles.
- Position-specific: made to precise measurements for an exact fit and easy installation in the front right position.
- Quality assured: its materials are tested to exacting government-regulated safety and durability standards.
- Durable design: made with EPDM rubber and specially coated, corrosion-resistant fittings.
Signs a brake hose may need replacing include cracks, bulges or fluid seepage along the hose, a soft or spongy brake pedal, or the vehicle pulling to one side when braking. These symptoms can have other causes, so inspect the brake system before replacing parts. The brake system must be bled after installation. Consult the vehicle service information for the correct procedure and for any fittings or washers required.
Interchange: 614313 · BH384111 · 2207053
This part cross-references / interchanges with the following part numbers:
614313, BH384111, 2207053
Frequently Asked Questions
What does the Dorman First Stop H622074 brake hydraulic hose do?
It is a flexible hose that carries pressurized brake fluid to the front right brake. It lets the wheel move with the suspension and steering while the fluid path stays sealed.
Does this brake hose fit the 2007-2010 Jeep Wrangler?
Yes. It is a direct-fit replacement for the front right position on the 2007-2010 Jeep Wrangler. Check the "Vehicles it fits" section for engine details.
What is the hose made of?
It is made with EPDM rubber and has specially coated, corrosion-resistant fittings. Its materials are tested to government-regulated safety and durability standards.
What are signs a brake hose may need replacing?
Look for cracks, bulges or fluid seepage on the hose, a soft or spongy pedal, or pulling to one side when braking. Inspect the brake system first, since other parts can cause these symptoms.
Do I need to bleed the brakes after installing it?
Yes. Replacing the hose opens the hydraulic system and lets air in, so the brakes must be bled afterward. Follow the vehicle service information for the correct procedure.
