Dorman - First Stop Drum Brake Wheel Cylinder P/N:W619012
Turn brake-pedal pressure into shoe-to-drum contact with the Dorman First Stop drum brake wheel cylinder, part number W610020. This rear left wheel cylinder is a direct-fit replacement for the 1999-2001 Honda Odyssey. Dorman engineered it to match the original cylinder's fit, function and performance, and it is manufactured and tested for quality assurance.
Inside the drum, the wheel cylinder takes hydraulic pressure from the master cylinder and uses it to press the brake shoes outward against the drum.
Signs this part may need replacing: brake fluid seeping from the wheel cylinder or wetting the inside of the drum or tire, a low or soft brake pedal, a dropping fluid level, or the vehicle pulling to one side when braking. If a leaking or sticking wheel cylinder is the cause, this unit replaces it. Diagnose the brake system before ordering.
This listing is for one rear left wheel cylinder. After installation, bleed the brake hydraulic system according to the vehicle service information.
Interchange: W-54304 · 072-9475 · 134.40300 · 135.40300 · 375-59027
W54304 · 0729475 · 13440300 · 13540300 · 37559027 · W906785 · 34193 · WC250730 · 43301S0X003 · 43301SX0003 · WC370088 · F139974 · WC139974
This part cross-references / interchanges with the following part numbers:
What does a drum brake wheel cylinder do?
It receives hydraulic pressure from the master cylinder and pushes the brake shoes outward against the drum. The W610020 is the rear left cylinder for the listed applications.
Does the Dorman W610020 fit the 1999-2001 Honda Odyssey?
Yes. It is cataloged as a direct-fit rear left drum brake wheel cylinder for the 1999-2001 Honda Odyssey.
What are the cups and boots made of?
Dorman makes the cups and boots on this wheel cylinder from high-quality EPDM rubber.
What are the signs of a failing wheel cylinder?
Common signs include brake fluid leaking at the drum, a soft or low pedal, and a dropping fluid level. Other parts can cause the same symptoms, so diagnose the brake system first.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic line lets air in, so bleed the brakes after installation using the procedure in the vehicle service information.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.