Get torque flowing back to the rear wheel with the Dorman OE Solutions Drive Axle Shaft, part number 630-225A, a direct-fit replacement for the 1983-1992 Ford Ranger, 1986-1997 Ford Aerostar and 1984-1990 Ford Bronco II. If a factory axle shaft has failed or been damaged by rust or a collision, this rear shaft is engineered to help restore the proper transfer of torque and rotational power from the differential or transmission to the wheel.
Engine-level fitment for each vehicle is listed in the Buyer's Guide tab.
Interchange: E3TZ4234C
This part cross-references / interchanges with the following part numbers:
Which vehicles does the Dorman 630-225A axle shaft fit?
It is a direct-fit replacement for the 1983-1992 Ford Ranger, 1986-1997 Ford Aerostar and 1984-1990 Ford Bronco II. See the Buyer's Guide tab for engine details.
What does a drive axle shaft do?
A drive axle shaft carries torque and rotational power from the differential or transmission to the wheel so that the wheel can drive the vehicle.
What position is this axle shaft for?
Dorman describes 630-225A as a left rear axle shaft, and the catalog lists it for the rear left and rear right positions.
What are signs an axle shaft may need replacing?
Signs include a shaft that is bent or damaged in a collision, heavy rust damage, or vibration or noise from the rear wheel area. Diagnose the cause before replacing the shaft.
How is this axle shaft installed?
Follow the vehicle's service information to install it. Replace related parts such as seals, bearings or fasteners as that procedure directs.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
