Dorman 599-228 control module for the 2010-2012 Ford Fusion 4-cylinder 2.5L, V6 3.0L or 3.5L and other vehicles replaces a module that has stopped operating the climate controls. This remanufactured unit is a direct replacement that matches the appearance and function of the original unit on specific vehicles.
- Fully tested replacement unit for swapping out the malfunctioning original module
- Function tested to ensure the same operation as the stock module
- Installation and setup need no advanced vehicle knowledge
Quick facts
- Part: Dorman 599-228 control module
- Also called: HVAC control module
- Fits: 2010-2012 Ford Fusion 4-cylinder 2.5L, V6 3.0L or 3.5L and other vehicles
- Condition: Remanufactured
If the climate controls stop responding or the vents ignore the settings, the module can be one cause. Before replacing it, look over the connectors with the ignition off for bent pins, corrosion or damage.
Fits
This control module fits the 2010-2012 Ford Fusion 4-cylinder 2.5L, V6 3.0L or 3.5L, the 2010-2012 Lincoln MKZ V6 3.5L and the 2011-2012 MKZ 4-cylinder 2.5L, and the 2010-2011 Mercury Milan 4-cylinder 2.5L or V6 3.0L.
Specifications
Fit and size
- Quantity per vehicle: 1
- Mounting type: Bolt on
- Connectors: 2, female
- Terminals: 4 and 26, male pin
Build and materials
- Condition: Remanufactured
- Country of origin: United States
In the box
One control module. This listing is one module, and the fitment calls for one per vehicle. Mounting hardware and an instruction manual are not included, and the old fasteners may not be reusable, so plan on new ones.
Installation notes
- This module needs a calibration procedure after installation is completed.
- Remove smart junction box fuse 15 for one minute. Switch the ignition to ON and wait 30 seconds, then turn it off, reinstall the fuse and switch the ignition to ON again. Wait 30 seconds and verify all vents are operating properly.
Interchange: CCM-113 · CCM 5
9E5H19980AN · 9E5H19980AR · 9E5H19980AS · 9E5H19980AT · 9E5Z19980G · 9E5Z19980K
This part cross-references / interchanges with the following part numbers:
9E5H19980AN, 9E5H19980AR, 9E5H19980AS, 9E5H19980AT, 9E5Z19980G, 9E5Z19980K, CCM-113, CCM 5
Frequently Asked Questions
Is this the HVAC control module for the 2010-2012 Ford Fusion 4-cylinder 2.5L, V6 3.0L or 3.5L?
Yes. Dorman 599-228 fits the 2010-2012 Ford Fusion with the 4-cylinder 2.5L, V6 3.0L or 3.5L engine.
Does the Dorman HVAC control module need calibration after installation?
Yes. Dorman 599-228 needs a calibration procedure once it is installed, using smart junction box fuse 15 and the ignition. The steps are in the installation notes on this page.
Does this remanufactured control module come with mounting hardware?
No. The listing is one control module only; mounting hardware and an instruction manual are not included.
How many connectors and terminals does this control module have?
It has two female connectors and male pin terminals, with terminal counts of 4 and 26. The mounting type is bolt on.
Can a failed control module keep the climate control vents from changing?
It can, if the module is the cause; a fuse or wiring fault can also stop them. A shop can test the module, since that needs the system powered.
