Dorman 686-408 front right steering knuckle for the 2017-2022 Honda CR-V connects the right front wheel to the suspension. This Dorman OE Solutions steering knuckle is a direct replacement, precision-engineered to match the dimensions of the original components.
- Cast steel body that resists rust and corrosion
- Crack-resistant construction
- Standard replacement grade
- Two caliper mounting holes and a sensor hole
Quick facts
- Part: Dorman 686-408 steering knuckle
- Fits: 2017-2022 Honda CR-V
- Position: Front right
- Material: Steel
- Condition: New
Knocking from the front end, uneven tire wear or a wheel sitting out of line after a curb strike can mean a damaged knuckle. These signs alone do not prove the knuckle is at fault; a worn ball joint is another common source. Replacing the front pair together is the usual practice, and this listing is one front right knuckle.
Fits
It is a direct-fit 2017-2022 Honda CR-V steering knuckle, and the front right position takes one. The front left is ordered separately.
Specifications
Fit and size
- Position: Front right
- Quantity per application: 1
- Caliper mounting holes: 2, 14.1 mm diameter
- Sensor hole diameter: 9 mm
Build and materials
- Construction: Cast
- Material: Steel
- Grade: Standard replacement
- Condition: New
- Country of origin: China
In the box
One steering knuckle and one bolt. The hub, axle and instruction manual are not included. Other mounting hardware is not included either, so plan on new fasteners, since the old ones may not be reusable.
Installation notes
- No special tools are needed for installation.
Interchange: 51211TLAA52 · 51211TNYA00
Frequently Asked Questions
Will Dorman 686-408 work as a steering knuckle assembly on the 2017-2022 Honda CR-V?
Yes. Dorman 686-408 is a front right steering knuckle for the 2017-2022 Honda CR-V. The front left side is a separate part.
Does Dorman 686-408 come with the hub or axle?
No. This listing is one steering knuckle and one bolt. The hub, axle, instruction manual and other mounting hardware are not included.
What size are the caliper mounting holes on this steering knuckle?
The two caliper mounting holes are 14.1 mm in diameter, and the sensor hole is 9 mm.
How can I tell if a front right steering knuckle is damaged?
Pulling to one side, a clunk over bumps or an off-center steering wheel after a hard impact can mean knuckle damage. A shop can inspect the knuckle itself.
Is 51211TLAA52 an interchange number for this steering knuckle?
Yes. 51211TLAA52 is listed as an interchange number for Dorman 686-408, along with 51211TNYA00.
