Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-084
$160.99
(You save)
Replace a worn front upper arm in one job with the Dorman control arm with ball joint, part number 520-084, a direct replacement for the original equipment on the 1989-1995 Toyota Pickup, 1993-1998 Toyota T100 and 2004-2005 Toyota Hilux. From the Dorman OE Solutions line, it installs in the front upper position. It connects the chassis to the steering knuckle through its ball joint and holds the wheel in place as the suspension moves.
Direct replacement: designed to take the place of the original assembly on the listed Toyota applications.
Complete repair: ships with the ball joint and bushings already installed, which saves time and labor.
Tested design: went through Dorman's industry-leading evaluation process, which is aimed at a smooth ride, directional stability and predictable dynamics.
Corrosion protection: additional coatings help it resist rust and corrosion.
Because this Dorman suspension control arm and ball joint assembly arrives as one piece, you don't need to press a separate ball joint or bushings into the old arm. Signs a front upper arm may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and play at the ball joint. Diagnose the cause before replacing parts, and have the wheel alignment checked after installation. Engine details for each application are in the Buyer's Guide tab.
This part cross-references / interchanges with the following part numbers:
3CB86535, CMS861304, 4806634030, 4806635080
Frequently Asked Questions
Does the Dorman 520-084 fit a 1993-1998 Toyota T100?
Yes. It is listed as a front upper replacement for the 1993-1998 Toyota T100. The Buyer's Guide tab shows every listed application with engine details.
Where does this control arm install?
It is cataloged for the front upper position. It connects the chassis to the steering knuckle through its ball joint.
Are the ball joint and bushings included?
Yes. The assembly comes with the ball joint and bushings pre-installed, so you don't need to press them into the old arm.
What are signs the upper control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear and play at the ball joint. Other suspension parts can cause similar symptoms, so diagnose before replacing.
Is an alignment needed after installing it?
Having the wheel alignment checked after replacing a control arm is recommended. Consult the vehicle service information for the correct fasteners, torque values and whether original bolts may be reused.
Write a Review
Dorman - OE Solutions
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-084
Help keep the front end steady and predictable with the Dorman control arm 520-520, a front right lower control arm with ball joint built to directly replace the original on the 1994-1999 Nissan...
Help bring back a stable front end under your SUV with the Dorman control arm from the OE Solutions line — this suspension control arm and ball joint assembly (MPN 520-019) is a direct-fit...
Deal with a worn front left lower arm in one step with the Dorman control arm 520-163, a direct replacement for the original assembly on the 2004-2012 Chevrolet Malibu, 2005-2010 Pontiac G6 and...
Suspension Control Arm And Ball Joint AssemblyThis suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
