Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Dorman 520-329 front left lower control arm with ball joint for the 1994-1999 Dodge Ram 1500 and other vehicles connects the front left wheel to the frame and carries the ball joint. This Dorman suspension control arm and ball joint assembly is a direct replacement for the original equipment.
A clunk over bumps, wandering steering or uneven front tire wear can mean this arm or its ball joint is worn, though a tie rod end or a sway bar link can be behind the same signs.
This is one of the control arms for the 1994-1999 Dodge Ram 1500, and it also fits the 1995-1996 and 1999 Dodge Ramcharger. This listing is one arm for the front left; the front right is a separate part, and the two sides of that axle are normally replaced at the same time.
Fit and size
Build and materials
One control arm with ball joint and mounting hardware. A grease fitting is not included. This listing holds one arm, and the front left side takes one; the front right is ordered separately.
Interchange: 52038407-L
52038407 · CA18025 · CK620480 · RK620480 · FA4469 · GS20376 · CMS20376 · 2605573 · 11CB25033 · JTC2358
This part cross-references / interchanges with the following part numbers:
Is this lower control arm made for the 1994-1999 Dodge Ram 1500?
Yes. Dorman 520-329 is the front left lower control arm with ball joint for the 1994-1999 Dodge Ram 1500, and it also fits the 1995-1996 and 1999 Dodge Ramcharger.
Does the Dorman lower control arm come with the ball joint and bushings?
Yes. Dorman 520-329 arrives with the ball joint and rubber bushings already installed, plus mounting hardware. A grease fitting is not included.
What is the Dorman control arm made of?
The arm is steel with a casting/forged construction and rubber bushings. Additional coatings give it resistance to rust and corrosion.
What are the dimensions of this front left control arm?
The arm measures 237 mm at its maximum length and 288.5 mm at its maximum width, with a 12.3 mm mounting hole. The ball joint thread diameter is 14 mm.
Does Dorman 520-329 replace part number 52038407-L?
Yes. 52038407-L is one of the numbers this Dorman control arm replaces; the rest are on the Interchange line of this page.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.