Replace a worn front left upper arm with this Dorman control arm, the Dorman - OE Solutions Control Arm with Ball Joint, part number 520-613. It is built as a direct replacement for the original equipment on the 1987-1990 Acura Legend. See the Buyer's Guide tab for engine-level details.
- Direct replacement: Directly replaces the original front left upper assembly on the listed application.
- Ready to install: The ball joint and bushings come pre-installed, which saves time and labor on the repair.
- Tested engineering: Dorman put it through its industry-leading evaluation process, which aims for a smooth ride, directional stability and predictable dynamics.
- Protective finish: Additional coatings provide rust and corrosion resistance.
A control arm connects the wheel assembly to the vehicle's frame. Its ball joint works as a pivot so the suspension can travel and the wheels can steer. This Dorman suspension control arm and ball joint assembly arrives as one unit, so the arm, ball joint and bushings are replaced in a single job.
Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and cracked or torn bushings. If a worn upper arm or ball joint is the cause, this assembly replaces it. Sold individually; replacing both sides together is recommended. Have the wheel alignment checked after installation.
Interchange: CA8076 · 51460SG0003 · 51460SG0010 · 51460SG0020 · 51460SG0030 · 3CB60448 · RK621630 · CMS60144 · 2605187 · 2606269
This part cross-references / interchanges with the following part numbers:
CA8076, 51460SG0003, 51460SG0010, 51460SG0020, 51460SG0030, 3CB60448, RK621630, CMS60144, 2605187, 2606269
