Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-196
Replace a worn front left upper arm in one step with the Dorman control arm 521-141, a direct replacement for the original equipment on the 2006-2011 Ford Crown Victoria, 2006-2011 Lincoln Town Car and 2006-2011 Mercury Grand Marquis. This Dorman suspension control arm and ball joint assembly went through an industry-leading evaluation process aimed at a smooth ride, directional stability and predictable dynamics.
The control arm links the wheel's steering knuckle to the vehicle's chassis, letting the wheel travel up and down while holding it in position, and the ball joint serves as the pivot for steering. Signs this part may need replacing include clunking over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing parts. This listing is for one arm in the front left upper position. Replacing both sides together is recommended, and a wheel alignment should follow installation. See the Buyer's Guide tab for engine details and the complete fitment chart.
Interchange: 622.61039
62261039 · TC5797 · CA10343 · 6W1Z3085B · CK80040 · K80040 · RK80040 · GK80040 · CMK80040 · MCSOE36 · 2605222 · 2605222M · 3CB40037 · SK521141 · 1508009 · X15CJ0129 · JTC1522
This part cross-references / interchanges with the following part numbers:
Does part 521-141 fit a 2006-2011 Ford Crown Victoria?
Yes. The 2006-2011 Ford Crown Victoria is among its listed applications, in the front left upper position. Check the Buyer's Guide tab to confirm your exact vehicle.
What does a Dorman suspension control arm do?
It connects the steering knuckle to the vehicle's chassis. This lets the wheel move up and down while it stays held in position. This arm fits the front left upper position.
Does it come with the ball joint and bushings?
Yes. The ball joint and bushings come pre-installed, so you do not have to press them in separately.
What are signs the upper control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Other parts can cause these symptoms too, so diagnose the cause before replacing.
Is a wheel alignment needed after installation?
Replacing a control arm can change the suspension geometry, so a wheel alignment is recommended afterward. Follow the vehicle service information for procedures and torque values.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.