Dorman 521-595 front left lower control arm with ball joint for the 2004-2008 Chrysler Pacifica connects the front left wheel assembly to the vehicle and lets it move with the suspension. This Dorman control arm is built as a direct replacement for the original equipment.
- Ball joint and bushings are pre-installed, saving time and labor
- Iron control arm, casting/forged type, with rubber bushings
- Additional coatings for rust and corrosion resistance
- Tested for a smooth, stable ride and directional stability
- Part of the Dorman OE Solutions line
Quick facts
- Part: Dorman 521-595 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2004-2008 Chrysler Pacifica
- Position: Front left lower
- Material: Iron control arm, rubber bushings
- Condition: New
A clunk over bumps, loose steering feel or uneven front tire wear can mean the ball joint or bushings are worn. Before you replace this arm, rule out a worn sway bar link, strut mount or tie rod end, since those parts can also change how the front end sounds and steers.
Fits
The 2004-2008 Chrysler Pacifica takes one of these on the front left. This listing is one arm; the front right arm on the same axle is a separate part and is normally replaced at the same time.
Specifications
Fit and size
- Position: Front left lower
- Quantity per application: 1
- Mounting hole diameter: 12.3 mm
- Ball joint thread diameter: 14 mm
- Maximum width: 288.5 mm
- Maximum length: 237 mm
Build and materials
- Control arm type: Casting/Forged
- Control arm material: Iron
- Bushing material: Rubber
- Ball joint stud type: Threaded
- Grade: Standard replacement
- Condition: New
- Country of origin: China
In the box
One front left lower control arm with ball joint and mounting hardware.
Installation notes
- The ball joint comes pre-greased.
- A grease fitting is not included.
Interchange: 622.63007 · 623.63007
4743477AD · 4743477AE · 4743477AF · 4743477AG · 4743477AH · 4743477AI · TC6373 · CA12453 · RK621361 · GS25179 · CMS25179 · 2606340 · 5CB25113 · SK521595 · 1506069 · JTC2619
This part cross-references / interchanges with the following part numbers:
622.63007, 623.63007, 4743477AD, 4743477AE, 4743477AF, 4743477AG, 4743477AH, 4743477AI, TC6373, CA12453, RK621361, GS25179, CMS25179, 2606340, 5CB25113, SK521595, 1506069, JTC2619
Frequently Asked Questions
Is the Dorman 521-595 control arm right for the 2004-2008 Chrysler Pacifica?
Yes, Dorman 521-595 is the front left lower control arm with ball joint for the 2004-2008 Chrysler Pacifica. The front right side is a separate part.
Does the Dorman suspension control arm and ball joint assembly come with the ball joint already installed?
Yes, the ball joint and bushings are pre-installed, and the ball joint is pre-greased. Mounting hardware is included, but a grease fitting is not.
What are the Dorman control arm bushings made of?
Rubber. The Dorman 521-595 has rubber bushings pre-installed on its iron control arm.
Is this Dorman lower control arm for the left or right side?
Dorman 521-595 is for the front left lower position only. The front right lower arm is a separate part, and each listing is sold as a single arm.
Does this Dorman suspension control arm have a rust-resistant coating?
Yes, additional coatings give the iron arm rust and corrosion resistance.
