Dorman 521-701 front left lower control arm with ball joint for the 2007-2010 Dodge Charger and other vehicles links the front wheel to the vehicle and pivots as the suspension moves.
- Part of the Dorman OE Solutions line
- Ball joint and bushings come pre-installed, which saves time and labor
- Iron control arm with rubber bushings
- Additional coatings resist rust and corrosion
- Pre-greased, with a threaded ball joint stud and a 14 mm thread diameter
- Tested for a smooth ride, directional stability and predictable dynamics
Quick facts
- Part: Dorman 521-701 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2007-2010 Dodge Charger and other vehicles
- Position: Front left lower
- Material: Iron
- Condition: New
Worn bushings or a worn ball joint can show up as clunking over bumps, loose or wandering steering, or uneven front tire wear. Tie rod ends, sway bar links or struts can be behind the same signs too, so find the cause before you buy this control arm and ball joint assembly.
Fits
This lower control arm for the 2007-2010 Dodge Charger also fits the 2005-2010 Chrysler 300 and the 2005-2008 Dodge Magnum, and it directly replaces the original equipment on these vehicles. Each of them takes one on the front left. The front left and front right arms are normally replaced together, but this listing is a single arm, so the front right is ordered separately.
Specifications
Fit and size
- Position: front left lower
- Quantity per vehicle: 1
- Mounting hole diameter: 12.3 mm
- Ball joint thread diameter: 14 mm
- Maximum width: 288.5 mm
- Maximum length: 237 mm
Build and materials
- Control arm type: casting/forged
- Control arm material: iron
- Bushing material: rubber
- Ball joint stud: threaded
- Grade: standard replacement
- Grease fitting: not included
- Condition: new
- Country of origin: Taiwan
In the box
One control arm with the ball joint and bushings installed, plus mounting hardware.
Interchange: 622.63046 · 623.63046
4895041AB · 4895041AC · 4895041AF · TC5984 · CA12402 · RK641533 · GS25177 · CMS25177 · 2606762 · 9CB25111 · SK521701 · X09CJ0685 · JTC2043
This part cross-references / interchanges with the following part numbers:
622.63046, 623.63046, 4895041AB, 4895041AC, 4895041AF, TC5984, CA12402, RK641533, GS25177, CMS25177, 2606762, 9CB25111, SK521701, X09CJ0685, JTC2043
Frequently Asked Questions
Will this control arm fit the 2007-2010 Dodge Charger?
Yes. The Dorman 521-701 fits the 2007-2010 Dodge Charger at the front left lower position, and that car takes one on that side.
Will this control arm fit the 2005-2010 Chrysler 300 on the front left?
Yes. This front left lower arm fits the 2005-2010 Chrysler 300. The front right side is a separate part.
Does this Dorman control arm come with the ball joint and hardware?
Yes. The Dorman 521-701 arrives with the ball joint and rubber bushings already installed, and mounting hardware is included. A grease fitting is not included.
How can I tell if the front left lower control arm is worn?
With the engine off, cracked or split bushings and rust damage on the arm can be seen. A clunk over bumps or uneven front tire wear can also point to wear, and a shop can check ball joint play.
What thread size does the ball joint stud on this control arm have?
The threaded ball joint stud has a 14 mm thread diameter. The mounting hole on this arm measures 12.3 mm.
