Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-936
Replace a worn front right lower arm in one step with this Dorman control arm, part number 521-714, a direct replacement for the original equipment on the 2003-2008 Honda Pilot and 2001-2006 Acura MDX. The ball joint and bushings are already installed, so the repair goes in as a single unit.
Because this is a Dorman suspension control arm and ball joint assembly, you don't have to press separate components into the arm. Dorman put the design through an industry-leading evaluation process intended to deliver a smooth ride, directional stability and predictable dynamics.
This Dorman lower control arm mounts in the front right lower position. It links the wheel assembly to the chassis and carries the ball joint, which acts as the pivot for steering and suspension travel. Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear and worn bushings. It is sold individually, and replacing the matching left-side arm at the same time is recommended. See the "Vehicles it fits" section for complete fitment details.
Interchange: 102-6447 · 810-96938B · 623.40023
1026447 · 81096938B · 62340023 · TC5577 · CA8543 · 51350S3VA00 · 51350S3VA01 · 51350S3VA03 · 51350S3VA10 · 51350S9VA00 · 5CB60083 · RK621350 · FA3052 · GS60106 · CMS60106 · 2606051 · SK521714 · 1509042 · X17CJ6576 · JTC2661
This part cross-references / interchanges with the following part numbers:
Is this the right lower control arm for a 2003-2008 Honda Pilot or 2001-2006 Acura MDX?
It is listed as the front right lower arm for the 2003-2008 Honda Pilot and the 2001-2006 Acura MDX. The "Vehicles it fits" section shows the full fitment chart.
What does this control arm do?
It links the wheel assembly to the chassis and lets the wheel move with the suspension. The ball joint on the arm acts as the pivot for steering and suspension travel.
What comes with this Dorman 521-714?
The arm comes with the ball joint and bushings pre-installed, so you don't need to press separate components into it.
What are signs the control arm may need replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, uneven tire wear and worn bushings. Diagnose the cause before replacing parts.
Do I need an alignment after installing it?
A wheel alignment is recommended after replacing a control arm. Consult the vehicle service information for fastener torque and whether the original fasteners may be reused.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.