Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-566
Help restore a smooth, stable ride with the Dorman control arm 521-893, a front left lower control arm with ball joint that directly replaces the original assembly on the 2007-2013 Acura MDX and 2010-2013 Acura ZDX. Dorman runs it through an industry-leading evaluation process aimed at a smooth ride, directional stability and predictable dynamics.
The lower control arm connects the steering knuckle to the vehicle's chassis. It lets the wheel travel up and down while holding it in position, and the ball joint provides the pivot for steering and suspension movement. Signs the arm may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear, and cracked or torn bushings. If a worn arm, ball joint or bushing is the cause, this unit replaces all three in one piece. A wheel alignment is recommended after installation. See the Buyer's Guide tab for complete fitment details.
Interchange: 102-7543
1027543 · TC6352 · CA14529 · 51360STXA03 · 51360STXA04 · 51360STXA05 · 51360STXA07 · 11CB60205 · RK622037 · GS601025 · CMS601025 · 2606731 · 1509059 · X02CJ0041
This part cross-references / interchanges with the following part numbers:
Which vehicles does this Acura MDX control arm fit?
It is a direct-fit front left lower control arm for the 2007-2013 Acura MDX and the 2010-2013 Acura ZDX. Check the Buyer's Guide tab for complete fitment details.
What does the Dorman suspension control arm and ball joint assembly do?
It connects the front wheel's steering knuckle to the chassis and lets the wheel move with the suspension. Its ball joint provides the pivot for steering.
What comes with the Dorman lower control arm 521-893?
The arm arrives with the ball joint and bushings pre-installed, saving time and labor. Check the vehicle service information for the correct fasteners and whether the originals may be reused.
What are signs this control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear, or cracked and torn bushings may point to a worn arm or ball joint. Diagnose the cause before you replace parts.
Which position does this arm fit, and is an alignment needed?
It is the front left lower control arm. A wheel alignment is recommended after installation so the suspension angles are set correctly.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.