Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:522-522
Tackle a worn front suspension corner with a 2005-2015 Toyota Tacoma lower control arm from Dorman OE Solutions. Part number 522-720 fits the front right lower position and is a direct replacement for the original equipment on the 2005-2015 Toyota Tacoma. See the Buyer's Guide tab for engine-specific fitment details.
The control arm connects the wheel end to the vehicle's frame, so the suspension can travel up and down while the wheel stays in position. The ball joint gives the steering a pivot point. Dorman puts this assembly through its evaluation process to support a smooth ride, directional stability and predictable dynamics.
This Dorman control arm arrives with its joint and bushings already in place, so the arm, ball joint and bushings are replaced in one job. Consider replacing the front left lower arm at the same time for balanced handling. Have the alignment checked after installation. Refer to the vehicle service information for torque values and for whether the original fasteners may be reused.
Interchange: 102-6429 · 810-84777B · 623.44066
1026429 · 81084777B · 62344066 · TC5788 · CA14636 · 9CB86337 · 9CB86337N · CK623263 · RK623263 · GS861039 · CMS861039 · 2606702 · SK522720 · 1525056 · X50CJ0516 · JTC2522 · 4806804040
This part cross-references / interchanges with the following part numbers:
Does this fit the 2005-2015 Toyota Tacoma?
Yes. Part number 522-720 is listed as a direct replacement for the 2005-2015 Toyota Tacoma in the front right lower position. See the Buyer's Guide tab for engine-specific details.
What does a control arm with ball joint do?
It connects the wheel end to the frame, which lets the suspension travel while keeping the wheel located. The ball joint provides a pivot point for steering movement.
What comes pre-installed on this assembly?
The ball joint and bushings come pre-installed on the arm, so you don't have to press them in separately. This saves time and labor.
What are signs this part may need replacing?
Clunking over bumps, loose or wandering steering, vibration or uneven tire wear may be signs of worn bushings or a worn ball joint. Diagnose the cause before replacing parts.
Is a wheel alignment needed after installation?
An alignment check is recommended after replacing a control arm. Follow the vehicle service information for torque values and for whether the original fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.