Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-602
Dorman 524-524 front right lower control arm with ball joint for the 2010-2012 Mercedes-Benz GLK300 and other vehicles links the wheel to the suspension and lets it move with the road. If the ball joint or bushings on this side are worn out, this Dorman OE Solutions suspension control arm replaces the arm, joint and bushings as one piece.
A worn ball joint or bushing can show up as a clunk over bumps, loose steering or uneven front tire wear. These signs alone do not prove this arm is at fault, since a worn tie rod end can feel similar.
The vehicles it fits include the 2010-2012 Mercedes-Benz GLK300, the 2013-2015 Mercedes-Benz GLK250 and the 2009-2015 Mercedes-Benz GLK350. This Dorman lower control arm directly replaces the original assembly on these vehicles. The 2010-2012 Mercedes-Benz GLK300 takes one on the front right; this listing is one arm, and the front left lower arm on the same axle is a separate part that is normally done at the same time.
Fit and size
Build and materials
One control arm and ball joint assembly with mounting hardware. A grease fitting is not included.
Interchange: 102-8050
TC6751 · CA5204 · 5CB10579 · RK622440 · 2043308211 · GS101231 · CMS101231 · 2607096 · 1514022 · X31CJ6725 · V302540
This part cross-references / interchanges with the following part numbers:
Is this Dorman control arm right for the 2013-2015 Mercedes-Benz GLK250?
Yes. Dorman 524-524 fits the front right lower position on the 2013-2015 Mercedes-Benz GLK250. If your car is a different model or year, look it up on the Buyer's Guide tab.
Do the Dorman control arm bushings come installed on this arm?
Yes. Dorman 524-524 comes with the rubber bushings and the ball joint already installed, and mounting hardware is included.
What size is the ball joint thread on this front right lower arm?
The threaded ball joint stud has a 14 mm thread diameter. The mounting hole measures 12.3 mm.
How can I tell if the ball joint on this arm is worn?
A clunk over bumps, loose steering or uneven front tire wear can mean a worn ball joint or bushing. Checking play needs the car raised, so a shop is the safe place to test it.
Is the Dorman OE Solutions control arm pre-greased?
Yes, this arm is pre-greased. A grease fitting is not included.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.