Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:526-639
Dorman 526-767 front left lower control arm with ball joint for the 2009-2015 Honda Pilot connects the front left wheel to the chassis. This Dorman control arm comes as a complete repair, with the ball joint and bushings pre-installed to save time and labor.
Clunking over bumps, uneven front tire wear or loose-feeling steering can point to a worn ball joint or bushing. These signs alone do not prove the arm is at fault, since a worn tie rod end can feel much the same.
This control arm for the 2009-2015 Honda Pilot is a direct replacement for the original assembly. This listing is one arm for the front left; the front right is a separate part, and the lower arm on the other side of that axle is normally replaced at the same time.
Fit and size
Build and materials
One control arm with mounting hardware; a grease fitting is not included. This listing holds one arm, and the front left of the 2009-2015 Honda Pilot takes one.
Interchange: 102-7545 · 810-321224B · 622.40105 · 623.40105
TC5772 · CA14725 · 51360SZAA02 · 51360SZAA03 · 51360SZAA04 · 51360SZAA05 · 51360SZAA06 · 51360SZAA07 · 5CB60269 · RK621550 · GS601043 · CMS601043 · 2606883 · 2606883M · 1509053 · X17CJ7788 · JTC2772
This part cross-references / interchanges with the following part numbers:
Is this the lower control arm for the 2009-2015 Honda Pilot?
Yes. Dorman 526-767 is the front left lower control arm for the 2009-2015 Honda Pilot. The front right side is a separate part.
What comes with the Dorman suspension control arm and ball joint assembly?
Dorman 526-767 is one front left lower arm with the ball joint and bushings already installed, plus mounting hardware. A grease fitting is not included.
What is the Dorman lower control arm made of?
The arm is aluminum with rubber bushings. It carries additional coatings for rust and corrosion resistance.
Could a clunk over bumps point to a worn control arm?
It can, because the ball joint and rubber bushings wear with use. Uneven front tire wear or loose-feeling steering can also be signs of wear there.
What size is the ball joint stud on Dorman 526-767?
The ball joint has a threaded stud with a 14 mm thread diameter. The arm has four 16 mm mounting holes and measures 573.6 mm long by 420 mm wide at most.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.