Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:527-512
$294.99
(You save)
Address the cracked arm and creaking ball joint behind many Tesla Model X front-end complaints with this Dorman control arm — the OE FIX suspension control arm and ball joint assembly (527-512) that drops in as a front upper right replacement for the 2016-2025 Tesla Model X. On some Model X SUVs the original front upper right arm can crack and separate from the steering knuckle, and the plastic cap over the ball joint tends to trap moisture and creak; this Dorman OE FIX design is engineered to address those failure points.
Forged steel construction: a forged steel ball joint housing with a stamped steel arm joined by rivets, designed to provide greater strength and reliability than the factory fiber-reinforced plastic arm.
Sealed ball joint: the ball joint is protected by a completely sealed housing to help keep out the moisture that causes the OE joint to creak and fail.
Corrosion protection: the plastic cap is eliminated so water can evaporate, and the arm is electrostatically coated to help resist corrosion.
Direct-fit design: engineered to match the fit of the factory assembly while exceeding OE performance and durability.
What is the Dorman 527-512 control arm and ball joint assembly?
It's a front upper right suspension control arm with an integrated ball joint — an OE FIX direct-fit replacement for the 2016-2025 Tesla Model X, pairing a forged steel ball joint housing with a stamped steel arm.
What problems does this OE FIX design address?
On some Tesla Model X SUVs the original plastic upper arm can crack and separate from the steering knuckle, and the plastic ball joint cap traps moisture and creaks. This forged steel design is built to address those points.
Does it fit my Tesla Model X?
It's designed as a front upper right fit for the 2016-2025 Tesla Model X. Confirm your specific vehicle in the Buyer's Guide tab before ordering.
How is the ball joint protected from moisture?
The ball joint sits in a completely sealed housing, and the design eliminates the OE plastic cap so trapped water can evaporate; the arm is also electrostatically coated to help resist corrosion.
Which part numbers does this replace?
It interchanges with CA13008, CMS95137, 102732700D, 102732700E, and 102732700G.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:527-512
Suspension Control Arm And Ball Joint AssemblyThis suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
