Swap out a worn 2005-2015 Toyota Tacoma lower control arm for the Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly CB74063RD, a front left lower unit that combines the control arm and ball joint in a single piece. It's designed to match the fit of the OE design on the listed severe-duty applications and drops in on the 2005-2015 Toyota Tacoma.
This is part of Dorman's RD ("rugged duty") chassis line, engineered for vehicles used in off-road work, heavy hauling, towing and other demanding commercial or emergency-service duty.
- Quenched-and-tempered steel housing: the ball joint housing uses quenched and tempered steel with an exclusive protective coating for added durability and corrosion resistance.
- Hardware included: the necessary hardware is supplied and also carries a corrosion-resistant coating.
- Pre-loaded joint: where applicable, the joint is pre-loaded with premium grease in a grease boot with molded-in standoffs to help keep lubrication in place.
- Direct replacement: a DORMAN control arm engineered to replace damaged or failed original equipment on the specified vehicles.
A signs-it-may-need-replacing checklist: clunking over bumps, loose or wandering steering, and uneven tire wear can point to a worn control arm or ball joint. If the front left lower arm is the cause, this assembly replaces it.
Interchange: CK623262 · CTXMS861038 · 4806904040
This part cross-references / interchanges with the following part numbers:
CK623262, CTXMS861038, 4806904040
