Dorman - OE Solutions Suspension Control Arm Bushing Kit P/N:534-411
$17.99
(You save)
Bring worn front upper control arm bushings back to spec with the Dorman - OE Solutions Suspension Control Arm Bushing Kit 534-411. It drops in as a direct-fit replacement for the 1996-2002 Toyota 4Runner (All engines), supplying two rubber-and-steel bushings that locate the front upper control arm and cushion suspension movement. Replacing tired bushings is fundamental to safe, proper vehicle operation — worn units can allow excess play that leads to clunking, imprecise alignment, and uneven tire wear.
Direct-fit design: precision-engineered to match the design and dimensions of the original components on the listed application.
Durable construction: built to strict standards from sturdy rubber and steel in a black finish, with materials chosen to reduce wear and resist corrosion and heat.
Complete repair: the kit includes all hardware needed to finish the job.
Rigorously tested: subjected to material-quality, in-vehicle, and long-term testing before release.
Each bushing measures 15 mm inside diameter, 20.5 mm outside diameter, and 53 mm in length and width. Package contents: 2 bushings. For even handling, it is good practice to service both sides together. Country of origin: Taiwan.
What vehicle does the Dorman 534-411 bushing kit fit?
It is a direct-fit replacement for the 1996-2002 Toyota 4Runner (All engines). See the Buyer's Guide tab to confirm the fit for your vehicle.
What is included in this kit?
The kit contains 2 control arm bushings plus all the hardware needed to complete the repair.
Where do these bushings go?
They install in the front upper control arm, where they locate the arm and cushion suspension movement.
What are the signs my control arm bushings may need replacing?
Worn bushings can allow excess play, which may show up as clunking, imprecise alignment, or uneven tire wear. Diagnose the cause before replacing.
Should I replace both sides at once?
It is good practice to service the bushings on both sides together for even, balanced handling, though it is a recommendation rather than a requirement.
Write a Review
Dorman - OE Solutions
Dorman - OE Solutions Suspension Control Arm Bushing Kit P/N:534-411
Renew the pivot points of your front lower control arms with the Dorman - OE Solutions Control Arm Bushing Kit, part number 534-242. It is a direct replacement for the 1987-1993 Mazda B2600, designed...
This suspension control arm bushing kit is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Reliable fit -...
Keep the front lower control arm located and pivoting as designed with the Dorman control arm bushing, part number 534-180. It is a direct-fit replacement for the front lower forward position on the...
Help restore a firm, quiet front end with the DORMAN control arm bushing, part number 534-150, a direct replacement for the front upper position on the 1997-2013 Chevrolet Corvette and 2004-2009...
Help firm up a tired front end with the DORMAN control arm bushing, part number 534-168 from Dorman - OE Solutions. It is a direct-fit replacement for the front lower rearward bushing position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
