Keep your suspension's control arm firmly located and quiet with the Dorman - OE Solutions Suspension Control Arm Bushing (535-392). This Dorman control arm bushing drops in as a direct-fit replacement for the 1995-2004 Toyota Tacoma [All], where it cushions the front lower control arm's pivot on the frame, isolates road vibration, and helps maintain proper suspension geometry. If a worn or cracked bushing is behind your clunks and loose handling, this replaces it — without swapping the entire control arm.
The listed 1995-2004 Toyota Tacoma application uses two bushings; each package contains one bushing, so order two for a complete replacement. Country of origin: Taiwan.
Interchange: TD5661W · MS86407 · 4865435080
This part cross-references / interchanges with the following part numbers:
Will this bushing fit my 1995-2004 Toyota Tacoma?
Yes — this control arm bushing is a direct-fit replacement for the 1995-2004 Toyota Tacoma [All]. Check the Buyer's Guide tab to confirm it matches your vehicle.
Is mounting hardware included?
No. Mounting hardware, a bracket, and a dust boot are not included. Consult the vehicle service information for the correct fasteners and whether they may be reused.
How many bushings do I need?
The listed 1995-2004 Toyota Tacoma application uses two. Each package contains one bushing, so order two for a complete replacement.
What are the signs of a worn control arm bushing?
Signs it may need replacing include clunking or rattling over bumps, imprecise or loose handling, vibration, and uneven tire wear. Diagnose the cause before replacing.
What is this bushing made of and where is it made?
It is built from rubber and steel with a rust-resistant coating. Country of origin: Taiwan.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
