Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-855
$65.99
(You save)
Firm up the connection between your Subaru's front suspension and chassis with the Dorman - OE Solutions Suspension Control Arm Bushing 540-855. It drops in as a direct-fit replacement for the 2015-2019 Subaru Legacy [All] and 2015-2019 Subaru Outback [All], serving the front left lower rearward control arm bushing position. A control arm bushing cushions the joint between the control arm and the chassis, absorbing road vibration while allowing controlled suspension movement. Worn or cracked bushings can allow extra play, leading to clunking, vibration, and imprecise handling — if a failed bushing is the cause, this part replaces it and lets you renew just the bushing instead of the whole control arm.
Direct-fit replacement: precision-engineered and rigorously tested to fit and perform like the original bushing on the listed applications.
Rust-resistant coating: the bushing is finished with a rust-resistant coating.
Serviceable repair: replace the worn bushing on its own rather than the entire suspension control arm.
Key specs: 45 mm outside diameter, 12.2 mm inside and mounting-hole diameter, 90 mm length, 120 mm between mounting holes, and a 55-75 Shore A durometer.
Mounting hardware is not included, and the bushing is not greaseable (no grease fitting). Package contains one bushing. Country of origin: Taiwan.
Interchange: FB972160 · BU20529 · 4672160 · 20219AL01A. Manufacturer part number 540-855 (also 540855).
This part cross-references / interchanges with the following part numbers:
FB972160, BU20529, 4672160, 20219AL01A
Frequently Asked Questions
What vehicles does the 540-855 bushing fit?
It's a direct-fit replacement for the 2015-2019 Subaru Legacy [All] and the 2015-2019 Subaru Outback [All]. Check the Buyer's Guide tab to confirm your exact vehicle.
Where is this bushing located?
The catalog lists it as the front left lower rearward control arm bushing position.
What does a control arm bushing do?
It cushions the connection between the control arm and the chassis, absorbing road vibration while allowing controlled suspension movement and helping keep the wheel located.
Does it include mounting hardware or a grease fitting?
No. Mounting hardware is not included and the bushing is not greaseable (no grease fitting). Consult the vehicle service information for the correct fasteners and whether they can be reused.
What are the bushing's dimensions?
It measures 45 mm outside diameter, 12.2 mm inside and mounting-hole diameter, 90 mm length, and 120 mm between mounting holes, with a 55-75 Shore A durometer.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-855
Keep your suspension tight and quiet with the Dorman - OE Solutions Suspension Control Arm Bushing 540-823. It installs as a direct-fit replacement in the front left lower rearward control-arm...
Suspension Control Arm BushingThis suspension control arm bushing is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct...
Suspension Control Arm BushingThis suspension control arm bushing is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.Direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
