Tame body roll and keep the rear sway bar tied into the suspension with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit (542-485). It installs as a direct-fit replacement for the rear suspension of the 1991-1997 Toyota Previa (All engines), connecting the stabilizer (sway) bar to the suspension so the bar can resist lean during cornering.
- Complete kit: supplies one stabilizer bar link, two ball joints, and two locking nuts, with mounting hardware included for the install.
- Greaseable service: greaseable design with a grease fitting, polymer bearings, and a dust boot to help keep out contaminants; it is not pre-greased.
- Steel construction: built from steel with a powder-coat or painted finish to resist rust and corrosion.
- Specs: Standard Replacement grade, 249 mm length, 10 mm end attachment sizes, and 1.5 mm thread pitch with male-threaded ends.
A worn stabilizer bar link often shows up as clunking or rattling from the suspension over bumps and looser-feeling handling. If a failed link is the cause, replacing it helps restore stability and control. Bolts and washers are not included — consult the vehicle service information for the correct fasteners and whether they may be reused. Country of origin: China. Manufacturer part number 542-485 (also 542485).
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does the 542-485 stabilizer bar link kit do?
It connects the rear stabilizer (sway) bar to the suspension so the bar can resist body lean during cornering, helping maintain stability and control on the 1991-1997 Toyota Previa.
Which vehicle does this kit fit?
It's a direct-fit replacement for the rear suspension of the 1991-1997 Toyota Previa (All engines). Check the Buyer's Guide tab to confirm fitment for your vehicle.
What comes in the kit?
The kit includes one stabilizer bar link, two ball joints, and two locking nuts, with mounting hardware included. Bolts and washers are not included.
Is this stabilizer bar link greaseable?
Yes. It has a greaseable design with a grease fitting, polymer bearings, and a dust boot. It is not pre-greased.
What are the signs my stabilizer bar link may need replacing?
Common signs include clunking or rattling from the suspension over bumps and looser-feeling handling. Diagnose the cause first, since other parts can produce similar symptoms.
Write a Review