Dorman - OE Solutions Suspension Trailing Arm P/N:524-352
$72.99
(You save)
Keep your suspension located and your ride composed with the Dorman - OE Solutions Suspension Trailing Arm 524-352. A trailing arm links the suspension to the chassis, controlling wheel movement while allowing normal suspension travel to help maintain ride quality and handling. It installs as a direct replacement for the 2006-2010 Kia Magentis and 2006-2010 Kia Optima (all engines), fitting and working like the original component.
Stamped steel construction: built from steel with a stamped design as a standard replacement.
Coated finish: a protective finish provides corrosion resistance.
Bracket ends, bolt-on: bracket-style ends at both ends, non-adjustable, and measures 419.5 mm in length.
Rubber bushings included: ships with rubber bushings; a ball joint is not included and none is installed.
Mounting hardware is not included — consult the vehicle service information for the correct fasteners and whether they may be reused. Worn trailing-arm bushings can produce clunking, imprecise handling, or shifting alignment; if a failed trailing arm is the cause, this replaces it. Country of origin: China. Manufacturer part number 524-352 (also 524352).
This part cross-references / interchanges with the following part numbers:
A trailing arm links the suspension to the chassis, controlling wheel movement while allowing normal suspension travel to help maintain ride quality and handling.
Which vehicles does it fit?
It's a direct replacement for the 2006-2010 Kia Magentis and 2006-2010 Kia Optima (all engines). Check the Buyer's Guide tab to confirm fitment for your vehicle.
Are bushings, a ball joint, or hardware included?
It includes rubber bushings. A ball joint is not included or installed, and mounting hardware is not included — consult the service information for the correct fasteners.
What are signs this trailing arm may need replacing?
Clunking or knocking over the suspension, imprecise handling, or shifting alignment can be signs of a worn trailing arm or its bushings. Diagnose the cause before replacing.
What is it made of and is it adjustable?
It's a stamped steel arm with a coated finish for corrosion resistance and measures 419.5 mm long. It is a non-adjustable, bolt-on standard replacement.
Write a Review
Dorman
Dorman - OE Solutions Suspension Trailing Arm P/N:524-352
Suspension Trailing ArmEngineered for passenger safety and rigorously tested for secure performance, this trailing arm was designed as a direct replacement for your vehicle's original part...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
