Replace a leaking or sticking rear left brake caliper with this 2005-2006 Honda CR-V caliper from Dynamic Friction Company, part number 331-59635. It is a direct-fit replacement for the rear left position on the 2005-2006 Honda CR-V with all engines. It belongs to DFC's Premium Calipers line and is built around a cast iron body and a single steel piston.
- Cast iron casting: The caliper body is made of cast iron.
- Single-piston design: It uses one steel piston with a 38 mm diameter.
- Bleeder screw included: The caliper comes with its bleeder screw.
- Pads not included: Brake pads are sold separately. Pair the caliper with the correct pad set for your vehicle.
When you press the brake pedal, hydraulic pressure pushes the caliper piston outward. The piston clamps the brake pads against the rotor to slow the wheel.
Signs this part may need replacing include:
- Brake fluid seeping at the caliper
- The vehicle pulling to one side under braking
- A brake that drags, or a wheel that runs hot
- Uneven pad wear
These symptoms can have other causes, so diagnose the brake system before replacing parts. If the original caliper is at fault, this unit replaces it.
The listed application uses a quantity of one per vehicle. This listing is for the rear left caliper only, and the opposite side is sold separately. After installation, bleed the brake system as directed in the vehicle service information.
Frequently Asked Questions
Does part 331-59635 fit the 2005-2006 Honda CR-V?
Yes. It is listed for the 2005-2006 Honda CR-V with all engines in the rear left position, with a quantity of one per vehicle.
Is this 2005-2006 Honda CR-V rear caliper for the left or right side?
It is the rear left caliper. The rear right side is a separate part and is not included in this listing.
Are brake pads or a bleeder screw included?
Brake pads are not included and must be purchased separately. The bleeder screw is included with the caliper.
How does a disc brake caliper work?
Hydraulic pressure from the brake pedal pushes the piston outward to clamp the pads against the rotor. This caliper uses a single 38 mm steel piston in a cast iron body.
What signs mean the caliper may need replacing?
Possible signs include fluid leaking at the caliper, pulling under braking, a dragging brake, or uneven pad wear. Diagnose the brake system first, since other parts can cause these symptoms.
