Keep your front brakes clamping evenly and quietly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-01005, also written 34001005). This front disc brake hardware kit is a direct-fit replacement for the 2007-2014 Suzuki SX4 and the 2012 Suzuki SX4 Crossover — see the Buyer's Guide tab for engine-level coverage. Fresh hardware restores the correct clips, springs, and abutment pieces so the pads seat, slide, and retract the way they should during a brake job.
Reusing old, rusted, or fatigued clips is a common cause of brake noise, uneven pad wear, and pads that stick or drag. Installing this kit alongside new pads is the recommended way to help ensure smooth, even front braking. If worn hardware is behind your brake noise or drag, replacing it addresses that cause.
What vehicles does this hardware kit fit?
It's a direct-fit front kit for the 2007-2014 Suzuki SX4 and the 2012 Suzuki SX4 Crossover. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Is this a front or rear brake hardware kit?
This is a front disc brake hardware kit for the listed Suzuki applications.
Why should I replace the brake hardware when I change pads?
Worn or corroded clips and springs can cause noise, uneven pad wear, and sticking pads. Fresh hardware helps the new pads seat, slide, and retract correctly.
What is included in this kit?
It supplies the disc brake hardware — such as the clips, springs, and abutment pieces — for the front brakes on the listed applications. It does not include brake pads.
Does the hardware resist corrosion and heat?
Yes. It's built for corrosion resistance, chemical resistance, and high heat resistance, with a low coefficient of friction to help the pads move freely.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
