Keep your rear brake pads properly seated, quiet, and free to move with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-03010). It installs as a direct-fit replacement set for the 2007-2009 Hyundai Santa Fe, refreshing the small clips, springs, and retainers that locate the rear brake pads in the caliper bracket so they stay positioned and slide as intended.
Over time, the original clips and springs can corrode, lose tension, or wear, which can lead to noise, uneven pad movement, or rattling. Fitting fresh hardware alongside new rear pads helps the pads index correctly and retract properly. This disc brake hardware kit covers the rear position on the listed application — see the Buyer's Guide tab to confirm it matches your exact vehicle.
What does this brake hardware kit do?
It supplies the clips, springs, and retainers that locate the rear disc brake pads in the caliper bracket, keeping them properly positioned and free to move for quiet, even braking.
What vehicle does the 340-03010 fit?
It is a direct-fit replacement for the 2007-2009 Hyundai Santa Fe. Check the Buyer's Guide tab to confirm it matches your exact vehicle.
Is this a front or rear kit?
This is a rear brake hardware kit, covering the rear position on the listed application.
Should I replace the hardware when installing new pads?
It's a good practice—corroded or fatigued clips and springs are best replaced with each pad service so the new pads seat correctly and slide freely.
What do the kit's features provide?
The hardware offers corrosion, chemical, and high-heat resistance plus a low coefficient of friction, helping the pads move smoothly while making assembly and removal easier.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
