Dynamic Friction Company Disc Brake Hardware Kit P/N:340-03022

Be the first to review this product
$7.99
MPN: 340-03022
UPC: 190920000447
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-03022
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-03022
$7.99

Keep your front brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-03022). This front brake hardware kit is a direct-fit replacement for the 2009-2015 Hyundai Sonata and 2011-2016 Kia Optima — see the Buyer's Guide tab for engine-level fitment. It refreshes the small but critical clips, springs, and hardware that locate the pads and allow them to slide as the brakes apply and release.

  • Corrosion resistance: helps the hardware stand up to road salt and moisture at the caliper.
  • High heat resistance: designed to hold up to the heat generated during braking.
  • Chemical resistance: intended to resist brake fluid, cleaners, and road contaminants.
  • Easy assembly and removal: made to simplify pad service and reinstallation.

The kit also carries a low coefficient of friction to help the pads move smoothly in the caliper hardware. Worn or rusted clips and springs can cause noise, uneven pad movement, or a pad that hangs up — if that hardware is the cause, replacing it with fresh components restores proper pad seating. It's good practice to fit new hardware whenever you install front pads for consistent, balanced braking across the axle.

Frequently Asked Questions

What vehicles does this front brake hardware kit fit?

It is a direct-fit replacement for the 2009-2015 Hyundai Sonata and 2011-2016 Kia Optima. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.

Is this hardware kit for the front or rear brakes?

This kit is cataloged for the FRONT brakes. It supplies the clips, springs, and hardware that locate the front disc brake pads.

What does a disc brake hardware kit do?

It provides the small clips, springs, and hardware that hold the pads in place and let them slide as the brakes apply and release, helping keep braking smooth and quiet.

Should I replace this hardware when I install new brake pads?

Yes, it is good practice to fit fresh hardware with every pad replacement. Worn or corroded clips and springs can cause noise or uneven pad movement.

Can worn brake hardware cause noise or a dragging pad?

It can. Rusted or damaged clips and springs may let a pad hang up or rattle. If that hardware is the cause, replacing it helps restore proper pad seating and movement.