Keep your rear disc brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N: 340-11006). This DFC hardware kit installs at the rear axle as a direct-fit replacement for the 2010-2012 Land Rover Range Rover and the 2010-2013 Land Rover Range Rover Sport — see the "Vehicles it fits" section for engine-level details. Fresh hardware helps the pads slide and retract properly so the caliper works as designed during a rear brake service.
Replacing worn or rusted clips, shims, and retainers whenever you fit new rear pads helps address noise, uneven pad wear, and sticking that can appear as old hardware fatigues. If failing rear brake hardware is the cause of your noise or drag, this kit replaces it.
What is this part?
It is a Dynamic Friction Company disc brake hardware kit (P/N: 340-11006) — the clips, shims, and retainers used when servicing the rear disc brakes on the listed vehicles.
Which vehicles does it fit?
It is a direct-fit replacement for the 2010-2012 Land Rover Range Rover and the 2010-2013 Land Rover Range Rover Sport. Check the "Vehicles it fits" section to confirm your vehicle.
Does this fit the front or rear brakes?
This kit is cataloged for the rear axle. It supplies the mounting hardware used during a rear disc brake service.
When should I replace the brake hardware?
Replace it whenever you install new rear pads, or if you notice brake noise, sticking, or uneven pad wear that may point to worn or corroded hardware. Diagnose the cause before replacing.
What features does this kit offer?
DFC lists corrosion and chemical resistance, high heat resistance, a low coefficient of friction for smooth pad movement, and easy assembly and removal.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
