Help keep your front brakes seated and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-13010). This front-position hardware kit is a direct-fit replacement for many vehicles, among them the 1998-2002 Subaru Forester, 2000-2001 Subaru Outback and 1997-2003 Subaru Impreza — see the Buyer's Guide tab for the full list and engine-level fitment.
When you install fresh pads, the small clips and hardware that locate and retain them should be renewed too — worn or corroded hardware can let pads chatter, drag, or wear unevenly.
Refreshing the front brake hardware alongside a pad service is intended to support proper pad movement on the listed Subaru applications.
What is a disc brake hardware kit and why replace it?
It's the small clips and hardware that locate and retain the front brake pads. Renewing it during a pad service helps prevent chatter, drag, and uneven pad wear from worn or corroded hardware.
Which vehicles does the 340-13010 kit fit?
It's a front-position direct-fit for many vehicles, among them the 1998-2002 Subaru Forester, 2000-2001 Subaru Outback and 1997-2003 Subaru Impreza. Check the Buyer's Guide tab for the full list.
Is this kit for the front or rear brakes?
This is a front disc brake hardware kit for the listed Subaru applications.
Should I install this when I replace my brake pads?
Yes. Renewing the hardware with each pad set is good practice, since heat and corrosion fatigue the clips over time and fresh hardware helps the pads move and seat correctly.
What makes this hardware durable?
DFC lists corrosion resistance, chemical resistance, and high heat resistance, plus a low coefficient of friction for smooth pad movement and easy assembly and removal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
