Dynamic Friction Company Disc Brake Hardware Kit P/N:340-26002

Be the first to review this product
$11.99
MPN: 340-26002
UPC: 190920703508
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-26002
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-26002
$11.99

Keep your rear disc brakes seating, sliding, and clamping the way they should with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-26002). This rear-position hardware kit is a direct-fit replacement for the 2017-2026 Tesla 3 and the 2023-2026 Tesla Y — see the Buyer's Guide tab for the full engine-level fitment on these applications. Fresh clips, springs, and abutment hardware help your pads move freely and stay properly located, which is often what quiet, even braking depends on when the original hardware has corroded or lost tension.

Corrosion resistance: designed to resist rust and the road salt that seizes worn hardware.
High heat resistance: built to hold up to the temperatures generated at the rear brakes.
Chemical resistance: stands up to brake fluid, cleaners, and road contaminants.
Low coefficient of friction & easy assembly: helps pads slide smoothly against the hardware and makes installation and future removal straightforward.

When you're servicing the rear brakes, replacing the small clips and springs at the same time is good practice — old, fatigued hardware is a common cause of uneven pad wear and noise. This DFC disc brake hardware kit gives you the fresh contact hardware to complete the job.

Frequently Asked Questions

What vehicles does this brake hardware kit fit?

It's a rear-position direct-fit for the 2017-2026 Tesla 3 and the 2023-2026 Tesla Y. Check the Buyer's Guide tab to confirm the match for your exact vehicle.

Is this a disc brake hardware kit for the front or rear?

This is a rear disc brake hardware kit, cataloged for the rear brake position on the listed Tesla applications.

What does a brake hardware kit include and do?

It supplies the small clips, springs, and abutment hardware that locate the pads and let them slide freely, which helps promote quiet, even braking when the originals are worn or corroded.

Why replace the hardware when I install new pads?

Fatigued or rusted clips and springs can cause uneven pad wear and noise. Fresh hardware helps the new pads seat and move correctly, so it's good practice to replace it during a brake job.

Are the brake pads included with this kit?

No. This listing is for the disc brake hardware kit only; brake pads are not included and should be ordered separately.