Keep your front disc brakes seating, sliding, and quieting the way they should with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-31008). This front-position hardware kit installs as a direct-fit replacement for the 1969-1971 BMW 1600, 1969-1971 BMW 1600-2, 1967-1976 BMW 2002, 1969-1971 BMW 1602, and 1969-1971 BMW 1800 — see the Buyer's Guide tab for engine-level detail.
Fresh brake hardware helps the pads move freely and stay properly located, addressing the rattles, uneven pad wear, and drag that worn or corroded clips and springs can cause. Refresh this hardware whenever you replace the front pads.
Installing a complete disc brake hardware kit with a fresh set of pads is good practice for consistent, quiet front braking.
What is this Dynamic Friction 340-31008 kit?
It's a front disc brake hardware kit — the clips, springs, and related hardware that locate and retain the brake pads. It replaces worn or corroded original hardware.
Which vehicles does it fit?
The 1969-1971 BMW 1600, 1600-2, 1602, and 1800, plus the 1967-1976 BMW 2002. Check the Buyer's Guide tab to confirm fitment for your vehicle.
Is this for the front or rear brakes?
This kit is cataloged for the front disc brake position on the listed BMW applications.
Should I replace hardware when I change pads?
Yes, it's good practice. Fresh hardware helps the new pads move freely and seat correctly, which supports even wear and quieter braking.
What symptoms suggest worn brake hardware?
Rattling or squeal from the front brakes, uneven pad wear, or pad drag can point to worn or corroded clips and springs. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
