Dynamic Friction Company Disc Brake Hardware Kit P/N:340-37006

Be the first to review this product
$7.99
MPN: 340-37006
UPC: 190920002250
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-37006
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-37006
$7.99

Keep your front disc brakes quiet, freely moving, and properly retained with the Dynamic Friction Company Disc Brake Hardware Kit 340-37006. This front-position hardware kit supplies the small but essential clips, springs, and fittings that locate the pads and let them slide and seat correctly in the caliper — the pieces that are meant to be renewed whenever you install fresh pads. It drops in as a direct-fit replacement for the listed front-brake applications.

Key features:

  • Corrosion & chemical resistance: helps the hardware resist rust and road chemicals for reliable, repeatable pad movement.
  • High heat resistance: holds up to the temperatures generated at the front brakes.
  • Low coefficient of friction: promotes smooth pad sliding to help limit bind, uneven wear, and noise.
  • Easy assembly & removal: designed for straightforward installation during a pad service.

Fits a wide range of GM applications, including the 1982-1992 Chevrolet Camaro, 1982-2003 Chevrolet S10, 1983-1994 Chevrolet S10 Blazer, 1978-1988 Chevrolet Monte Carlo, 1991-2003 GMC Sonoma, 1996-2000 Isuzu Hombre, and 1982-1992 Pontiac Firebird. See the Buyer's Guide tab for the full list of covered vehicles and engines.

Frequently Asked Questions

What is included in a disc brake hardware kit?

This kit supplies the front disc brake hardware — the clips, springs, and fittings that locate and retain the pads and let them slide correctly in the caliper. Exact contents vary by application; see the listing details.

Does this hardware fit front or rear brakes?

It is a front-position disc brake hardware kit, cataloged for the front brakes on the listed applications.

Should I replace brake hardware when I install new pads?

Yes. This hardware is meant to be renewed with each pad service; fresh clips and springs help the new pads seat, slide, and stay retained for consistent brake operation.

Will this kit fit my vehicle?

It is a direct-fit replacement for many GM applications, including the Chevrolet Camaro, S10, Monte Carlo, GMC Sonoma, and Pontiac Firebird. Check the Buyer's Guide tab to confirm your exact year, make, and model.

Can worn brake hardware cause noise or uneven pad wear?

Yes. Corroded or fatigued hardware can let pads bind or move improperly, which may contribute to noise or uneven wear. If failed hardware is the cause, replacing it with this kit addresses it.