Keep your front brakes quiet, tight, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-39011, also written 34039011). This front-position kit supplies the clips, springs, and fasteners that locate the pads and let the caliper slide, and it installs as a direct-fit replacement for the 2003-2009 Chrysler PT Cruiser and 2003-2005 Dodge Neon — see the Buyer's Guide tab for engine-level fitment.
Fresh hardware is the piece most often overlooked at a pad change, yet worn clips and abutment springs are a common source of rattle, uneven pad wear, and sticking. Replacing it with a new disc brake hardware kit helps every component seat and move the way it should.
Replace your brake hardware whenever you service the front pads for a clean, rattle-free result on the listed applications.
What vehicles does this front hardware kit fit?
It is a direct-fit replacement for the 2003-2009 Chrysler PT Cruiser and the 2003-2005 Dodge Neon. Check the Buyer's Guide tab to confirm your exact application.
Is this a front or rear kit?
This is a front disc brake hardware kit for the listed applications.
What comes in the kit?
It supplies the clips, springs, and fasteners that position the brake pads and allow the caliper to slide on the listed applications.
Should I replace the hardware when I change my brake pads?
Yes. Fresh hardware is recommended with every pad change, since worn clips and springs are a common cause of rattle, sticking, and uneven pad wear.
What benefits does this hardware offer?
It's designed for corrosion, chemical, and high-heat resistance, with a low coefficient of friction for smooth pad movement and easy assembly and removal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
