Keep your rear brakes clamping quietly and precisely with the Dynamic Friction Company Disc Brake Hardware Kit (MPN 340-40016). This rear brake hardware kit is a direct-fit replacement for the 2006-2014 Dodge Charger, supplying the fresh clips, springs and hardware that locate the pads and keep them moving freely against the caliper and bracket. Reusing worn, rusted or fatigued hardware is a common cause of brake noise, uneven pad wear and sticking pads, so refreshing it during a pad service helps everything seat and slide the way it should.
Install this rear disc brake hardware kit alongside new pads for the listed application. For the full engine breakdown, see the Buyer's Guide tab.
What vehicle does this hardware kit fit?
It is a direct-fit rear brake hardware kit for the 2006-2014 Dodge Charger. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
What is a disc brake hardware kit?
It is the set of clips, springs and hardware that positions the brake pads and lets them slide freely against the caliper and bracket for quiet, even braking.
Should I replace the hardware when I do a brake job?
Yes, it is best practice. Worn or corroded clips can cause noise, sticking pads and uneven wear, so fresh hardware helps new pads seat and move correctly.
Does this kit position on the rear axle?
Yes, this is a rear disc brake hardware kit for the listed Dodge Charger application.
Does this kit include brake pads?
No. This kit supplies the mounting hardware only; pair it with a new set of brake pads for the listed application.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
