Keep your front disc brakes clamping quietly and evenly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-42002). This DFC front hardware kit supplies the clips, springs, and abutment pieces that locate the pads, control rattle, and let them slide freely during braking — the small parts that wear, corrode, or take a set over time and are best renewed whenever you install fresh pads. It installs as a direct-fit replacement for the front axle on the 1990-2001 Jeep Cherokee, 1990-1992 Jeep Comanche, 1993-1998 Jeep Grand Cherokee, 1993 Jeep Grand Wagoneer, 1997-2006 Jeep TJ, 1990 Jeep Wagoneer, and the Jeep Wrangler (1990-1995 and 1997-2006). See the Buyer's Guide tab for engine-level details.
Refreshing the hardware alongside new pads helps restore proper pad movement and can reduce noise if worn clips are the cause.
What is included in this kit?
It supplies the front disc brake hardware — the clips, springs, and abutment pieces that locate the pads and control rattle. It does not include brake pads.
Which axle does this fit?
This is a FRONT disc brake hardware kit for the listed Jeep applications. See the Buyer's Guide tab to confirm fitment for your vehicle.
Does it fit my Jeep Wrangler?
It is listed for the 1990-1995 and 1997-2006 Jeep Wrangler. Check the Buyer's Guide tab against your exact year and configuration.
Why replace the brake hardware?
Clips and springs can corrode, wear, or lose tension over time, which may cause noise or uneven pad movement. Fresh hardware helps the pads slide freely.
Should I install this with new pads?
Yes, replacing hardware whenever you install fresh pads is good practice, since worn clips and springs can affect pad movement and braking noise.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
