Keep your front brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-42005, also written 34042005). This front brake hardware kit drops in as a direct-fit replacement for the 1999-2004 Jeep Grand Cherokee, supplying the fresh clips, springs, and small hardware that keep the front disc brakes properly located during service.
Brake hardware takes a beating from heat, road salt, and constant thermal cycling, so worn or corroded clips can let pads rattle, drag, or sit unevenly. Replacing this hardware when you install new pads helps the assembly move as designed.
Fresh hardware is inexpensive insurance every time the pads come off, helping restore proper clip tension and pad guidance on the front axle.
What vehicle does this hardware kit fit?
It is a direct-fit replacement for the front brakes of the 1999-2004 Jeep Grand Cherokee. See the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this a front or rear kit?
This is a front disc brake hardware kit, supplying the clips and small hardware for the front axle brakes.
Should I replace brake hardware when installing new pads?
Replacing the hardware with new pads is good practice, since heat, corrosion, and thermal cycling wear out clips and springs and can let pads drag or rattle.
What is the part number for this kit?
The manufacturer part number is 340-42005, also written 34042005.
What does this hardware kit do?
It provides the fresh clips, springs, and small hardware that locate the front disc brake pads and keep them moving freely so the brakes operate as designed.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
