Dynamic Friction Company Disc Brake Hardware Kit P/N:340-45005

Be the first to review this product
$7.99
MPN: 340-45005
UPC: 190920003110
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-45005
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-45005
$7.99

Keep your rear brakes seating, sliding, and quieting the way the factory intended with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-45005, also written 34045005). This rear brake hardware kit installs as a direct-fit replacement on the 2010-2016 Buick LaCrosse, 2010 Buick Allure, 2011-2017 Buick Regal, 2011 Saab 9-5, 2013-2015 Chevrolet Malibu, and 2014-2020 Chevrolet Impala. It refreshes the small but critical clips, springs, and retainers that position the pads and let them move freely against the rotor — the pieces most brake jobs should renew rather than reuse.

Features:

  • Corrosion resistance to help the hardware hold up against road salt and moisture at the rear axle.
  • High heat resistance for the temperatures generated during braking.
  • Chemical resistance against brake fluid, cleaners, and road contaminants.
  • Low coefficient of friction to help the pads slide smoothly, along with easy assembly and removal during service.

Worn or rusted hardware can leave pads dragging, rattling, or wearing unevenly. If tired clips and springs are the cause of those symptoms on your rear brakes, this kit replaces them. For best results, install fresh hardware whenever you service the rear pads.

Frequently Asked Questions

What is a disc brake hardware kit?

It's the set of clips, springs, and retainers that position the brake pads and let them slide freely against the rotor. Renewing them during a brake job helps keep the pads seated and moving properly.

Does this kit fit the front or rear brakes?

This is a rear brake hardware kit. It is cataloged for the rear axle on the listed applications.

Which vehicles does P/N 340-45005 fit?

It fits the 2010-2016 Buick LaCrosse, 2010 Buick Allure, 2011-2017 Buick Regal, 2011 Saab 9-5, 2013-2015 Chevrolet Malibu, and 2014-2020 Chevrolet Impala. See the Buyer's Guide tab for full details.

Should I replace brake hardware every time I do the pads?

It's good practice. Clips and springs lose tension and corrode over time, so installing fresh hardware with new pads helps ensure even wear and quiet operation.

Can worn hardware cause brake noise?

Yes. Rusted or fatigued clips and springs can let pads rattle, drag, or wear unevenly. If worn hardware is the cause, replacing it with this kit addresses those symptoms.