Keep your front brakes quiet, properly seated, and rattle-free with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-46001). This front disc brake hardware kit is a direct-fit replacement for a wide list of GM applications, including the 1985-1990 Buick Electra, 1983-1989 Chevrolet Celebrity, 1985-1989 Cadillac DeVille, 1983-1989 Oldsmobile Cutlass Ciera, and 1983-1989 Pontiac 6000 — see the Buyer's Guide tab for the full list of covered vehicles.
Brake hardware positions and retains the pads and caliper components at the front axle, holding everything in alignment so the pads move freely and seat correctly. Replacing this hardware whenever you install fresh pads helps address squeal, clatter, and uneven pad movement caused by worn or fatigued components.
What is this disc brake hardware kit for?
It supplies the front-axle hardware that positions and retains the disc brake pads and caliper components, keeping them aligned so the pads move and seat correctly.
Does this fit the front or rear brakes?
The catalog lists this as a FRONT disc brake hardware kit for the covered applications.
Which vehicles does P/N 340-46001 fit?
It fits many 1983-1990 GM models, including the Buick Electra, Chevrolet Celebrity, Cadillac DeVille, Oldsmobile Cutlass Ciera, and Pontiac 6000. See the Buyer's Guide tab for the complete list.
Should I replace the hardware when I install new pads?
Replacing worn brake hardware alongside new pads is good practice, since fatigued components can cause noise and uneven pad movement.
Can this hardware fix brake noise?
If worn or fatigued front brake hardware is the cause of squeal or rattle, replacing it with this kit addresses that. Diagnose the noise first, as it can have other causes.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
