Keep your rear disc brakes quiet, properly aligned, and easy to service with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-47050). This rear-position kit supplies the clips, springs, and small hardware that locate the pads and manage their movement in the caliper, and it drops in as a direct-fit replacement for the 2003-2006 Chevrolet Silverado 1500, the 2007 Chevrolet Silverado 1500 Classic, and the 2003 GMC Sierra 1500 — see the Buyer's Guide tab for engine-specific fitment.
Fresh hardware is the piece most people forget at a brake job, yet worn or corroded clips are a common source of rattles, uneven pad wear, and sticking pads. This DFC disc brake hardware kit is built to restore that mounting hardware on the rear axle.
Replace the hardware whenever you install new rear pads for consistent, rattle-free operation.
What position does this hardware kit fit?
It is a rear disc brake hardware kit — it services the rear-axle brakes on the listed applications.
Which vehicles does the 340-47050 kit fit?
It fits the 2003-2006 Chevrolet Silverado 1500, the 2007 Chevrolet Silverado 1500 Classic, and the 2003 GMC Sierra 1500. Check the Buyer's Guide tab for engine-specific fitment.
What comes in this kit?
It supplies the clips, springs, and small mounting hardware that locate the rear pads and manage their movement in the caliper. Pads and rotors are not included.
Should I replace the hardware when I do a brake job?
Yes. Installing fresh hardware with new pads is best practice, since worn or corroded clips can cause rattles, sticking pads, and uneven pad wear.
Why do the clips have a low coefficient of friction?
The low-friction design is intended to let the pads slide freely against the hardware, which helps reduce binding and can promote more even pad wear.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
