Dynamic Friction Company Disc Brake Hardware Kit P/N:340-54011

Be the first to review this product
$7.99
MPN: 340-54011
UPC: 190920004391
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-54011
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-54011
$7.99

Keep your front disc brakes quiet, correctly seated, and rattle-free with the Dynamic Friction Company Disc Brake Hardware Kit 340-54011. This front disc brake hardware kit installs as a direct-fit replacement for the listed applications, including the 1984-1993 Ford Mustang, 1992-1994 Ford Crown Victoria, 1982-1987 Lincoln Continental, 1981-1994 Lincoln Town Car, and 1981-1994 Mercury Grand Marquis — see the Buyer's Guide tab for the full list of Ford, Lincoln, and Mercury fitments.

A brake hardware kit supplies the small clips, springs, and retaining hardware that locate and secure the disc brake pads. Fresh hardware is inexpensive insurance during a pad job, helping keep the pads properly positioned so they slide, seat, and wear the way they should.

  • Corrosion & chemical resistance: built to hold up against road salt, moisture, and brake-service chemicals.
  • High heat resistance: designed to withstand the heat generated at the caliper and pad interface.
  • Low coefficient of friction: promotes smooth pad movement against the abutment surfaces.
  • Easy assembly & removal: intended for a straightforward install during routine brake work.

If worn or corroded hardware is causing pad rattle, uneven pad wear, or noise, replacing it with this kit addresses those clips and springs.

Frequently Asked Questions

What is included with the Dynamic Friction 340-54011 kit?

It is a disc brake hardware kit that supplies the clips, springs, and retaining hardware used to locate and secure the disc brake pads at the front.

Which vehicles does this hardware kit fit?

It is a direct-fit replacement for listed Ford, Lincoln, and Mercury applications such as the 1984-1993 Ford Mustang and 1981-1994 Lincoln Town Car. See the Buyer's Guide tab for the full list.

Is this a front or rear brake hardware kit?

This kit is cataloged for the front disc brakes on the listed applications.

Should I replace brake hardware when I install new pads?

Replacing the hardware during a pad service is good practice, since fresh clips and springs help keep the pads properly positioned and moving freely.

Can worn hardware cause brake noise?

Yes. If corroded or worn clips and springs are the cause of pad rattle, noise, or uneven pad wear, replacing them with this kit addresses that hardware.