Keep your front brakes quiet, aligned, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (MPN 340-54026, also written 34054026). This front disc brake hardware kit drops in as a direct-fit replacement for the 2008-2011 Ford Focus, refreshing the small clips, springs, and abutment hardware that position the pads and let them slide as the brakes apply and release.
Worn, rusted, or missing hardware can let pads bind, rattle, or wear unevenly, so fresh clips and springs are recommended whenever you install new front pads. This kit supplies replacement front hardware for the listed application; see the Buyer's Guide tab for engine-level fitment. Confirm the parts against your original hardware before installing, and follow the vehicle service information for proper positioning and any specified fasteners.
What vehicle does this hardware kit fit?
It is a direct-fit front replacement for the 2008-2011 Ford Focus. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
What is a disc brake hardware kit?
It is the set of clips, springs, and abutment hardware that locate the front pads and let them slide as the brakes apply and release.
Should I replace the hardware when I install new pads?
Yes, fresh hardware is recommended with every front pad replacement. Worn or rusted clips can cause binding, rattles, and uneven pad wear.
Does this kit resist heat and corrosion?
Yes. The hardware offers corrosion and chemical resistance for the wheel-well environment plus high heat resistance for the temperatures braking generates.
Is this front or rear hardware?
This is front disc brake hardware for the listed Ford Focus application. It features a low coefficient of friction so the pads move smoothly during operation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
