Help keep your front brakes quiet, tight, and correctly located with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-54077). This front disc brake hardware kit installs as a direct-fit replacement for many vehicles, among them the 1993-2007 Ford Taurus, 1995-1998 Ford Windstar and 1996-1997 Ford Thunderbird — see the Buyer's Guide tab for the full list and engine-level details on your specific vehicle.
Fresh hardware helps seat new pads properly, limit noise, and keep the caliper working smoothly. If worn or corroded brake hardware is causing your front-brake noise or uneven pad wear, replacing it with this kit addresses that hardware. Always replace hardware whenever you fit new pads, and consult the vehicle service information for the correct torque and procedure.
What is a disc brake hardware kit and what does it do?
It replaces the hardware for the front disc brakes that positions the pads and controls their movement, helping them slide and retract as intended.
Which vehicles does the 340-54077 kit fit?
It fits the front brakes of many vehicles, among them the 1993-2007 Ford Taurus, 1995-1998 Ford Windstar and 1996-1997 Ford Thunderbird. See the Buyer's Guide tab for the full list.
Is this hardware for the front or rear brakes?
This kit is cataloged for the front disc brakes on the listed applications.
Should I replace the hardware when I install new pads?
Yes. Fresh hardware is recommended with every pad replacement so the pads seat and slide correctly, which helps limit noise and uneven wear.
Will this fix my brake noise?
If worn or corroded brake hardware is the cause of the noise, this kit replaces it. Diagnose the cause first, as noise can stem from pads or other components.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
