Keep your front disc brakes quiet and your pads properly located with the Dynamic Friction Company Brake Hardware Kit (P/N 340-56015). This front hardware kit installs as a direct-fit replacement for the 1968 Cadillac Eldorado, 1965-1967 Ford Thunderbird, 1965-1969 Lincoln Continental, and 1966 Mercury Marauder.
A disc brake hardware kit supplies the small clips, springs and retaining hardware that hold the brake pads in the correct position within the caliper. Fresh hardware helps the pads seat, slide and retract as intended, which supports even pad wear and reduces the rattling and noise that worn or corroded clips can cause. Replacing this hardware whenever you service the pads is good practice.
What is a disc brake hardware kit?
It's the set of clips, springs and retaining hardware that hold the disc brake pads in the correct position within the caliper and let them slide and retract as intended.
Which vehicles does the 340-56015 kit fit?
It fits the 1968 Cadillac Eldorado, 1965-1967 Ford Thunderbird, 1965-1969 Lincoln Continental, and 1966 Mercury Marauder. See the Buyer's Guide tab to confirm your vehicle.
Is this a front or rear kit?
This is a front disc brake hardware kit for the listed applications.
Should I replace the hardware when I install new brake pads?
It's good practice. Fresh clips and springs help the new pads seat, slide and retract correctly, which supports even pad wear and can reduce brake noise.
Can worn brake hardware cause noise?
Yes. Worn or corroded clips and springs can let the pads rattle or move improperly. If failed hardware is the cause of your brake noise, this kit replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
